Datalogic QLM500 Manual de Instruções descarregar pdf (Página 65)

CBX ELECTRICAL CONNECTIONS

4.1.1 Ultra High Power Illuminator Models

Matrix 410 655-0x0 models require 24 Vdc. Power must be supplied to both the reader

(19-pin connector) and the Ultra High Power internal illuminator (M12 4-pin male connector).

This can be done from the CBX through the spring clamp terminal pins. Matrix 410™

receives power through the 25-pin cable connector while the illuminator receives power using

the CAB-LP-0x accessory cable connected directly between the illuminator and the CBX.

Connect the Brown/White wires to Vdc and Black/Blue wires to GND. Connect the cable

shield to Earth ground.

Figure 47 - Power Supply Connections for Matrix 410 655-0x0 Models

4.2 MAIN SERIAL INTERFACE

CAUTION

Do not connect to the Main Interface spring clamp terminals if using Host

Interface Modules (Fieldbus) with the CBX500.

The signals relative to the following serial interface types are available on the CBX spring

clamp terminal blocks.

The main serial interface type and its parameters (baud rate, data bits, etc.) can be

defined by the user via VisiSet™ software. The RS485 half duplex is automatically set

whenever MUX32 communication protocol is enabled. For more details refer to the

"Communication" folder in the VisiSet™ Help On Line.

Details regarding the connections and use of the interfaces are given in the next paragraphs.

From 24 Vdc Power Supply

V+

Earth

Ground

VGND

CAB-LP0x to Ultra High Power Illuminator

(brown)

(white)

(black)

(blue)

shield

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 160 161

Sem comentários

Datalogic QLM500 Manual de Instruções Página 65