Datalogic GWY-01-PBS-01 Especificações descarregar pdf (Página 15)

GWY-01-DNT-01 MANUAL – REV. 02 CHAPTER 1:

GETTING STARTED

PAGE 15 OF 67

Figure 1-3: Subnet16 ThinNet Cable

7. For ThickNet Networks: Using a 5-pin, female, 7/8 - 16, ThickNet to

Bare Wire Leads cable (EMS P/N: CBL-1495-XX), connect the bare

wires to your power supply (SHIELD wire connected to GND). Attach the

female, ThickNet end to the 5-pin, male, ThickNet end on a Drop-T

connector (EMS P/N: CBL-1526).

8. For ThinNet Networks:

Using a 5-pin, female, M12, ThinNet to Bare

Wire Leads cable (EMS P/N: CBL-1494-XX), connect the bare wires to

your power supply (SHIELD wire connected to GND). Attach the female,

ThinNet end to the 5-pin, male, ThinNet end on a Drop-T connector

(EMS P/N: CBL-1486).

Figure 1-4: Subnet16 ThickNet Cable

9. Attach a DeviceNet-compatible data cable to the 5-pin, male M12

interface connector on the Gateway. Connect the other end of this cable

to your DeviceNet network.

10. Turn your power supply ON. The green PWR (power) LED on the

Gateway will illuminate. After the boot process is complete, the amber

DeviceNet LED will also glow to indicate that the Gateway is in

DeviceNet mode. The “DeviceNet” LED may appear green or red (solid

or flashing) depending on the status of the connection with your

DeviceNet network (see Table 2-2 in Section 2.2.1

for the behavior of the

Gateway’s DeviceNet LED).

OPTIONAL STEPS FOR ADDITIONAL CONFIGURATION

Steps 11 - 12 below are considered optional and only need to be completed by users

that wish to modify their Gateway’s internal configuration.

11. To modify the Gateway’s internal configuration, connect a USB cable to

the USB interface connector on the Gateway. Connect the other end of

this cable to a USB port on your host computer.

12. Download the Cobalt Dashboard Utility from www.ems-rfid.com

and

install the software on your host computer. Use the Dashboard Utility to

connect, via USB, to the Gateway. You will then be able to use the

Cobalt Dashboard Utility to configure the Gateway and send RFID

commands for testing purposes.

XX = length in Meters

GWY-01-DNT-01 DEVICENET FACTORY DEFAULTS

Node Address:

Data Rate:

125Kb (via 5-pin DeviceNet connection)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 66 67

Comentários a estes Manuais

Sem comentários

Datalogic GWY-01-PBS-01 Especificações Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Gateways/controladores Datalogic GWY-01-PBS-01