Datalogic QLM700 Manual de Instalação

QLM700 INSTALLATION MANUAL Figure A 1 Power In Connector and LED 6 Profinet IO Port 2 Connector and LED 2 ID-NET Connector and LED

QLM700 INSTALLATION MANUAL 10 10) Preset the Node Address of the QLM700, as shown in the Profinet IO Network Address Selectors paragraph. 11) Switc

QLM700 INSTALLATION MANUAL 11 INDICATOR LEDS There are six Indicator LEDs which signal power, I/O and Profinet IO communication activity and are vis

QLM700 INSTALLATION MANUAL 12 TYPICAL LAYOUTS The following figure shows the general system layout. Figure 4 – General System Layout The dotte

QLM700 INSTALLATION MANUAL 13 The following diagrams are examples showing layout connections and are not intended to represent power limits, which in

QLM700 INSTALLATION MANUAL 14 TECHNICAL FEATURES ELECTRICAL FEATURES Supply Voltage 10 to 30 Vdc Consumption 0.3 - 0.2 A Maximum Distributed Cur

QLM700 INSTALLATION MANUAL 15 COMPLIANCE POWER SUPPLY This product is intended to be installed by Qualified Personnel only. This device is intend

DECLARATION OF CONFORMITY EC-128 Rev.: 2 Pag.: 1 di 1 Datalogic Automation S.r.l. Via Lavino 2

QLM700 INSTALLATION MANUAL 2 UPDATES AVAILABILITY UK/US The latest documentation updates for this product are available on Internet. Log on to: w

QLM700 INSTALLATION MANUAL 3 DESCRIPTION The QLM700 Profinet IO Gateway is an active connection module which can be used in Standalone or ID-NET™ Ma

QLM700 INSTALLATION MANUAL 4 PACKAGE CONTENTS Verify that the QLM700 and all the parts supplied with the equipment are present and intact when open

QLM700 INSTALLATION MANUAL 5 MECHANICAL INSTALLATION QLM700 can be mounted to various surfaces using the two M5x20 screw and washers included in the

QLM700 INSTALLATION MANUAL 6 ELECTRICAL CONNECTIONS CONNECTORS PWR-IN (Power In) M12 5P Male (A-coded) ID-NET (Out) M12 5P Female (A-coded) Pin Fu

QLM700 INSTALLATION MANUAL 7 PWR-IN PWR-IN is a 5-pin Male A-Coded M12 connector. Input power must only be supplied to the QLM700 at the PWR-IN conn

QLM700 INSTALLATION MANUAL 8 Pins 2 and 3 on the ID-NET connector carry the same power supply lines present on pins 1 and 3 of the PWR-IN connector;

QLM700 INSTALLATION MANUAL 9 ETH1 CONNECTOR ETH1 is a 4-pin Female D-Coded M12 connector. It is used to connect the QLM700 to a Profinet IO network