Datalogic DX8200A-3010 Manual de Instalação descarregar pdf (Página 51)

CUSTOM CABLE ELECTRICAL CONNECTIONS

Note that GND is internally connected to chassis. The cable shield is also connected to pin 1

- CHASSIS.

DX8200

USER INTERFACE

23/25

GND

V- (Ground)

V+ (20

–

30 V dc)

9/13

HASSIS

Earth Ground

Cha ssis

Figure 35 – Power Supply Using the 26-pin Connector (Vdc models)

Vac models:

The supply voltage for correct operation of the scanner must be between 110 and 230 VAC.

The max. power consumption is 48 VA including startup current.

24 Vdc is generated and available on the 26-pin connector and can be used to power

external devices through a correctly jumpered CBX100/CBX500, i.e. photocell, etc. This

voltage however cannot be used to propagate power for a Lonworks network.

A security system allows the laser to activate only once the motor has reached the correct

rotational speed; consequently, the laser beam is generated after a slight delay from the

power on of the scanner.

4.2 MAIN SERIAL INTERFACE

The main serial interface is compatible with the following electrical standards:

RS232

RS485 full-duplex

RS485 half-duplex

The main interface type and the relative parameters (baud rate, data bits, etc.) can be

set using the Genius™ utility program or the Genius™ based Host Mode Programming

procedure. For more details refer to the section "Main Serial Port" in the Genius™

Help On Line.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 138 139

Sem comentários

Datalogic DX8200A-3010 Manual de Instalação Página 51