Datalogic DX8200A-3010 Manual de Instalação descarregar pdf (Página 112)

DX8200A REFERENCE MANUAL

NOTE

In the vast majority of systems the x and z data are not necessary. For

these cases set x = 0, z= 0 during the calibration procedure.

3. Press the Calibrate button for Position 1 to start the calibration.

4. Repeat the same procedure for Position 2 and Position 3.

5. Press the “Validate Calibration” button to validate the calibration settings.

6. Repeat the whole procedure for Leg 2.

Before closing the dialog box, press the Run Test button to test the calibration results and

efficiency. See the following figure.

Figure 97 – Testing PackTrack™ Calibration

Repeat the entire procedure for each scanner in the Reading Station.

9.3 PERFORMANCE

The scan rate is 1000 scans/sec (500 scans on each leg).

Refer to the diagrams in par. 9.4 for further details on the reading features. These diagrams

are taken o

n various resolution sample codes at a 25 C ambient temperature depending on

the conditions listed under each diagram.

If standard models do not satisfy specific requirements, contact your nearest Datalogic

distributor, supplying code samples, to obtain complete information on the reading

possibilities.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 138 139

Sem comentários

Datalogic DX8200A-3010 Manual de Instalação Página 112