Datalogic DX8200A-3010 Manual de Instalação descarregar pdf (Página 54)

DX8200A REFERENCE MANUAL

4.2.3 RS485 Half-Duplex Interface

NOTE

This interface is provided for backward compatibility. We recommend using

the more efficient Lonworks network for Master/Slave or Multiplexer layouts.

The RS485 half-duplex (3 wires + shield) interface can be used for polled communication

protocols.

It can be used for Multidrop connections with a Datalogic Multiplexer, (see par. "Multiplexer"

in Appendix A) exploiting a proprietary protocol based

on polled mode called MUX32

protocol, where a master device polls slave devices to collect data. The overall maximum

cable length should not exceed 1200 m (3940 ft).

The following pins of the 26-pin connector are used for RS485 half-duplex interface

connection:

Pin Name Function

2 RTX+ RS485 input/output (+)

4 RTX- RS485 input/output (-)

7 GND_ISO Main signal ground

DX8200

7 GND_ISO

RTX485+

RTX485-4

RS485REF

MULTIPLEXER

RTX485-

RTX485+

Earth

Ground

CHASSIS

Figure 40 – RS485 Half-Duplex Interface Connections

This interface is forced by software when the protocol selected is MUX32 protocol.

In a Multiplexer layout, the Multidrop address must also be set via serial channel by the

Genius™ utility or by the Host Programming Mode.

Figure 41 shows a multidrop configuration with DX8200A scanners connected to a

Multiplexer.

CAUTION

This is an example of multidrop wiring. Consult the multiplexer manual for

complete wiring instructions.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 138 139

Sem comentários

Datalogic DX8200A-3010 Manual de Instalação Página 54