Datalogic DS4800 Manual do Utilizador descarregar pdf (Página 15)

Setup Procedure Using Programming Barcodes

6 NETWORK STATUS MONITOR LOCK – UNLOCK BARCODE

For Master

scanners with display (or connected to a CBX500 with accessory display), the

Network Status Monitor shows diagnostic messages regarding the network. It can be

enabled/disabled through two different methods:

 by means of a Genius™ parameter

 with a programming barcode

The programming barcode procedure uses the AutoLearn Mode as described in chapter 1.

The code below is a “toggle-code”:

 if the Network Status Monitor is disabled, the programming code enables it.

 if the Network Status Monitor is enabled, the programming code disables it.

Ì$+NETDISP$-GÎ

Network Status Monitor

On the Master display the following messages are shown:

1 N e t w o r k 1 5

* * * * * - - - - - - - - - -

1 6 N e t w o r k 3 1

- - - - - - - - - - - - - - - -

Where:

= Device OK

= Device not detected at startup

= Device detected at startup but not responding to polling

= Device with diagnostic error

The DS4800 has a two-line display and so the messages alternate.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Sem comentários

Datalogic DS4800 Manual do Utilizador Página 15