Datalogic QuickScanQS6500BT Especificações Página 215
- Página / 336
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Code 93
Product Reference Guide 6-127
Code 93 — continued
Truncate Leading/Ending
The leading or ending digits of bar code data characters can be trun-
cated. Select from 00 (no truncation) to 15.
NOTE
The imager will beep instead of reading anything when
the truncate value is more than the bar code data digits
or the truncate leading value overlaps the truncate end-
ing value.
START
MODE BARCODE
Sets from 00 to 15 characters to truncate from either the leading or ending charac-
ters of scanned bar code data. To configure this feature, scan the “START” bar
code above to place the unit in Programming Mode, then the SET TRUNCATION:
LEADING or SET TRUNCATION: ENDING, followed by the digits from the Alpha-
numeric table in
Appendix B, Alpha-Numeric Pad representing the desired
quantity of digits to trumcate from the message string. Accept your selection by
scanning the “SET” bar code below and finally, exit programming mode by scan-
ning the “END” barcode below.
DEFAULT SETTING FOR THIS FEATURE: 00 (None)
Set Truncation:
Leading
Set Truncation:
Ending
SET
END
- Product Reference Guide 1
- Disclaimer 2
- Table of Contents 3
- Product Reference Guide iii 5
- Product Reference Guide v 7
- QuickScan 10
- QS6500/QS6500BT 10
- Getting Started 11
- Nomenclature 12
- Symbologies 13
- Linear Imager Settings 13
- Return to Factory Defaults 13
- Bluetooth Models 15
- Unlinking 16
- Battery Charging 17
- Paging the Imager 17
- General Features 19
- 3-2 QuickScan 20
- Imager Timeout 21
- Read Verification 22
- LED and Beeper Indicators 24
- Good Read: When to Indicate 25
- Good Read Beep Control 26
- Good Read Beep Frequency 26
- Good Read Beep Length 27
- 3-10 QuickScan 28
- Good Read Beep Volume 29
- Scanning/Imaging Features 30
- Scan Mode — continued 31
- Stand Mode LED 32
- Scan Illumination LED Timeout 32
- Inverted Image Scan 33
- Global Features 34
- Global Maximum Code Length 35
- Interface Related 37
- Features 37
- Product Reference Guide 4-3 39
- Interface Selection 40
- Product Reference Guide 4-5 41
- 4-6 QuickScan 42
- Product Reference Guide 4-7 43
- Interface Features 44
- RS-232 Interface Features 45
- 4-10 QuickScan 46
- Hardware Flow Control 47
- Intercharacter Delay 47
- Software Flow Control 47
- 4-12 QuickScan 48
- Product Reference Guide 4-13 49
- Host Echo 50
- Host Echo Quiet Interval 50
- Signal Voltage: Normal/TTL 50
- RS-232 Invert 50
- Product Reference Guide 4-15 51
- Beep on ASCII BEL 52
- Beep on Not on File 52
- ACK NAK Options 52
- Product Reference Guide 4-17 53
- ACK Character 54
- NAK Character 55
- Retry on ACK NAK Timeout 56
- ACK NAK Timeout Value 57
- ACK NAK Retry Count 58
- ACK NAK Error Handling 59
- 4-24 QuickScan 60
- IBM-USB Interface Features 61
- 4-26 QuickScan 62
- Keyboard Wedge/USB Keyboard 63
- 4-28 QuickScan 64
- Product Reference Guide 4-29 65
- 4-30 QuickScan 66
- Product Reference Guide 4-31 67
- 4-32 QuickScan 68
- Set Wedge Quiet Interval 68
- Product Reference Guide 4-33 69
- Appendix B, Alpha 69
- Numeric Pad 69
- Wand Emulation — cont 71
- Interface Related Features 74
- Data Editing 75
- Please Keep In Mind 76
- Prefix/Suffix — continued 77
- 00 - 22 Characters (ASCII) 79
- Insert Groups 79
- Product Reference Guide 5-7 81
- 5-8 QuickScan 82
- Data Editing Overview 83
- 5-10 QuickScan 84
- Data Group Characters 85
- Product Reference Guide 5-13 87
- Case Conversion 88
- Disable/Enable UPC-A 90
- Expand UPC-A to EAN-13 90
- UPC-A — continued 91
- Disable/Enable UPC-E 99
- Truncate/Expand 99
- UPC-E — continued 100
- Disable/Enable EAN-13 108
- Checksum Transmission 108
- ISBN/ISSN 108
- EAN-13 — continued 109
- Disable/Enable EAN-8 119
- EAN-8 — continued 120
- Disable/Enable GTIN 128
- Code I.D. Selection 128
- GTIN — continued 129
- Disable/Enable RSS-14 130
- UCC/EAN 128 Emulation 130
- RSS-14 — continued 131
- RSS Expanded 137
- RSS Expanded — continued 138
- RSS Limited 144
- RSS Limited — continued 145
- Disable/Enable Code 39 151
- Checksum Verification 151
- Checksum Transmit 151
- Code 39 — continued 152
- Pharmacode 39 161
- Pharmacode 39 — continued 162
- Code 128 168
- Code 128 — continued 169
- Format as EAN-128 176
- EAN-128 — continued 177
- Interleaved 2 of 5 178
- Product Reference Guide 6-91 179
- Fixed Length Control 180
- Product Reference Guide 6-93 181
- Appendix B 181
- Alpha-Numeric Pad 181
- Minimum/Maximum Code Length 182
- Truncate Leading/Ending 183
- Product Reference Guide 6-97 185
- Product Reference Guide 6-99 187
- Industrial 2 of 5 188
- Industrial 2 of 5 — continued 189
- Matrix 2 of 5 (Eur) 195
- 6-108 QuickScan 196
- QS6500/QS6500 BT 196
- 6-112 QuickScan 200
- Product Reference Guide 6-113 201
- Group Characters 201
- 6-114 QuickScan 202
- Disable/Enable Codabar 203
- Codabar — continued 204
- Start/End Type 211
- Start/End Transmission 211
- Disable/Enable Code 93 212
- Code 93 — continued 213
- Disable/Enable Code 11 220
- Code 11 — continued 221
- MSI/Plessey 228
- MSI/Plessey — continued 229
- UK-Plessey 236
- UK-Plessey — continued 237
- Disable/Enable Telepen 244
- Telepen — continued 245
- Standard 2 of 5 252
- Standard 2 of 5 — continued 253
- Code 16K 260
- Code 16K — continued 261
- China Post 266
- China Post — continued 267
- Disable/Enable PDF 417 273
- Escape Sequence Transmit 273
- PDF 417 — continued 274
- Micro PDF 417 279
- Micro PDF 417 — continued 280
- EAN UCC Composite 285
- EAN UCC Composite — continued 286
- Code 4/5 291
- Code 4/5 — continued 293
- Bluetooth Features 297
- Auto Update — continued 298
- Deep Sleep Mode 299
- Leash Alarm 300
- Bluetooth Connectivity Mode 302
- Inquiry Beep Control 304
- Specifications 307
- Interface Cables) 308
- IBM Port 5B/9B/17 309
- Product Specifications 310
- ASCII Conversion 311
- A-2 QuickScan 312
- B-2 QuickScan 314
- Keyboard Function 315
- Key Mappings 315
- C-2 QuickScan 316
- Product Reference Guide C-3 317
- C-4 QuickScan 318
- Product Reference Guide C-5 319
- C-6 QuickScan 320
- Product Reference Guide C-7 321
- C-8 QuickScan 322
- Default Settings 323
- Interface Default Exceptions 324
- RS-232 Wincor/Nixdorf 325
- Keyboards 326
- Wand Emulation 326
- List Commands 327
- E-2 QuickScan 328
- Chapter F 329
- LED & Beeper Indications 329
- F-2 QuickScan 330
- Product Reference Guide F-3 331
- Sample Symbols 333
- Sample Symbols — continued 334
Manuais e produtos relacionados com Leitores de códigos de barras Datalogic QuickScanQS6500BT
(94 páginas)
(2 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.077 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais