Datalogic QuickScanQS6500BT Especificações descarregar pdf (Página 201)

Matrix 2 of 5 (Eur)

Product Reference Guide 6-113

Matrix 2 of 5 (Eur) — continued

Matrix 2 of 5 Data Group Characters

Once you’ve pre-set your desired Data Group Characters

using the Data

Group Characters

feature found in Chapter 5, Data Editing, you can choose

to output up to two of those pre-sets whenever a Matrix 2 of 5 bar code

is scanned.

To set this feature:

1. Determine which Data Group pre-set(s) to output. You can select

up to two from the following:

Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4

For example, your choice might be Data Group 2 only; Data

Groups 1 and 3; Data Groups 3 and 4; or no Data Groups.

2. Scan the START bar code to place the imager in Programming

Mode.

3. Scan the SET MATRIX 2 OF 5 DATA GROUP CHARACTERS

bar code.

4. Turn to

Appendix B, Alpha-Numeric Pad and scan the digits repre-

senting the Data Group designation(s) chosen in the first step

above. A digit of value zero (0) selects “no group.” For example,

scanning 3 and 0 would output only the character(s) set for Data

Group 3 whenever a Matrix 2 of 5 bar code was scanned. Scanning

digits 1 and 2 would output both Data Groups 2 and 3. To select

no Data Groups at all, scan 0, then 0 again.

5. Scan the SET bar code to accept the digits scanned.

6. Scan the END bar code to exit Programming Mode.

1. In that chapter, you can select which character(s) and position(s) to place Data Characters

within scanned data output.

NOTE

The options in this section set Data Group Characters

for the Matrix 2 of 5 symbology ONLY. If you wish to

enable this feature for additional symbologies, turn to

the options in the section specific to the other symbol-

ogy(s).

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 335 336

Sem comentários

Datalogic QuickScanQS6500BT Especificações Página 201