Datalogic QuickScan QS6500BT Especificações Página 101
- Página / 388
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Product Reference Guide 91
Chapter 10
Wand Emulation Interface
Introduction
This chapter provides feature/settings configuration for the Wand Emulation interface.
Wand Emulation Standard Factory Settings
Reference Appendix B, Standard Defaults for a listing of standard factory settings.
Wand Idle State
This feature specifies the level of the Wand output signal when the reader is idle.
NOTE
ENTER/EXIT PROGRAMMING MODE
Wand Idle State = Low
Wand Idle State = High
DEFAULT
TTL logic levels:
0V <= Low <= 0.7V
2.4V <= High <= 5.25V
- QuickScan 1
- Product Reference Guide 1
- Table of Contents 3
- Chapter 1 11
- Introduction 11
- Manual Conventions 12
- References 12
- Technical Support 13
- 4 QuickScan 14
- Chapter 2 15
- Getting Started 15
- Connecting at 16
- Disconnecting at 16
- Programming 17
- Select the Interface Type 18
- Configure Interface Settings 18
- Configure Other Features 18
- Software Version Transmission 19
- 10 QuickScan 20
- Chapter 3 21
- Interfaces 21
- Table 1. Available Interfaces 22
- Global Interface Features 25
- USB Suspend Mode 26
- Chapter 4 27
- General Features 27
- 18 QuickScan 28
- Label Gone Timeout 29
- Label Gone Timeout — cont 30
- LED and Beeper Indicators 31
- Good Read: When to Indicate 32
- Good Read Beep Type 33
- Good Read Beep Frequency 34
- Good Read Beep Length 34
- Good Read Beep Volume 36
- Good Read LED Duration 37
- 2 seconds 38
- Scanning Features 39
- Scan Mode — continued 40
- Stand Mode Triggered Timeout 41
- 32 QuickScan 42
- Scanning Active Time 43
- Scanning Active Time — cont 44
- Flash On Time 45
- Flash On Time — cont 46
- Flash Off Time 47
- Flash Off Time — cont 48
- Stand Mode Sensitivity 49
- Green Spot Duration 50
- Chapter 5 51
- RS-232 ONLY Interface 51
- Baud Rate — continued 52
- Data Bits 53
- Stop Bits 54
- Handshaking Control 56
- Chapter 6 57
- RS-232/USB-Com Interfaces 57
- Intercharacter Delay 58
- Intercharacter Delay — cont 59
- Beep On ASCII BEL 60
- Beep On Not on File 60
- ACK NAK Options 61
- ACK Character 62
- ACK Character — cont 63
- NAK Character 64
- NAK Character — cont 65
- ACK NAK Timeout Value 66
- ACK NAK Timeout Value — cont 67
- ACK NAK Retry Count 68
- ACK NAK Retry Count — cont 69
- ACK NAK Error Handling 70
- Indicate Transmission Failure 71
- Disable Character 72
- Disable Character — cont 73
- Enable Character 74
- Enable Character — cont 75
- 66 QuickScan 76
- Chapter 7 77
- Keyboard Interface 77
- Country Mode 78
- Country Mode — continued 79
- Caps Lock State 81
- Send Control Characters 82
- Wedge Quiet Interval 83
- Wedge Quiet Interval — cont 84
- Intercode Delay 87
- Intercode Delay — cont 88
- USB Keyboard Speed 89
- 80 QuickScan 90
- Chapter 8 91
- USB-OEM Interface 91
- USB-OEM Device Usage 92
- USB-OEM Interface Options 93
- 84 QuickScan 94
- Chapter 9 95
- IBM 46XX Interface 95
- 46xx Number of Host Resets 96
- 88 QuickScan 98
- IBM Standard Format — 99
- Code 39 Format — 99
- IBM 46XX Interface Options 100
- Chapter 10 101
- Wand Emulation Interface 101
- Wand Polarity 102
- Wand Signal Speed 103
- Options are: 104
- Wand Transmit Noise 105
- 96 QuickScan 106
- Chapter 11 107
- Data Editing 107
- Please Keep In Mind 108
- Global Prefix/Suffix 108
- Global AIM ID 110
- Global AIM ID — continued 111
- GS1-128 AIM ID 112
- Label ID 113
- 104 QuickScan 114
- 115
- Label ID — continued 117
- Case Conversion 127
- Character Conversion 128
- 120 QuickScan 130
- Chapter 12 131
- Symbologies 131
- Disable All Symbologies 132
- Coupon Control 133
- UPC-A Enable/Disable 134
- UPC-A — cont 135
- UPC-E Enable/Disable 137
- UPC-E — cont 138
- GTIN Formatting 141
- EAN 13 Enable/Disable 142
- EAN 13 — cont 143
- EAN-13 ISBN Conversion 144
- ISSN Enable/Disable 144
- EAN 8 Enable/Disable 146
- EAN 8 — cont 147
- UPC/EAN Global Settings 149
- 140 QuickScan 150
- UPC/EAN Correlation 151
- UPC/EAN Price Weight Check 152
- UPC-A Minimum Reads 153
- Optional Add-ons 154
- Add-Ons — cont 155
- GS1 DataBar 165
- Omnidirectional 165
- 156 QuickScan 166
- Expanded 167
- 158 QuickScan 168
- 01 = Length 1 is 1 Character 171
- Limited 174
- GS1 DataBarTM Limited — cont 175
- Code 39 Enable/Disable 176
- Code 39 — cont 177
- Code 39 Stitching 192
- Code 32 Enable/Disable 193
- 184 QuickScan 194
- Code 128 195
- Code 128 — cont 196
- GS1-128 Enable 210
- Interleaved 2 of 5 (I 2 of 5) 211
- 202 QuickScan 212
- I 2 of 5 Minimum Reads 214
- 2 of 5 Decoding Level 215
- 2 of 5 Decoding Level — cont 216
- I 2 of 5 Length Control 217
- I 2 of 5 Set Length 1 218
- 06 = Length 1 is 6 Characters 219
- I 2 of 5 Set Length 2 220
- I 2 of 5 Set Length 2 — cont 221
- 212 QuickScan 222
- I 2 of 5 Stitching 223
- Interleaved 2 of 5 CIP HR 224
- Datalogic 2 of 5 224
- Datalogic 2 of 5 — cont 225
- Codabar Enable/Disable 236
- Codabar — cont 237
- ABC Codabar 254
- ABC Codabar — cont 255
- Code 11 Enable/Disable 257
- Code 11 — cont 258
- Code 11 Decoding Level 268
- Code 11 Stitching 271
- Standard 2 of 5 272
- Standard 2 of 5 — cont 273
- Standard 2 of 5 Stitching 281
- Industrial 2 of 5 282
- Industrial 2 of 5 — cont 283
- IATA Enable/Disable 291
- ISBT 128 292
- ISBT 128 Concatenation Mode 293
- ISBT 128 — cont 294
- MSI Enable/Disable 296
- MSI — cont 297
- MSI Decoding Level — cont 305
- Plessey Enable/Disable 306
- Plessey — cont 307
- Code 93 — cont 317
- Codablock F 328
- Codablock F — cont 329
- Code 4 Enable/Disable 335
- Code 4 — cont 336
- Code 5 Enable/Disable 337
- Code 5 — cont 338
- Code 4 and 5 Decoding Level 339
- 330 QuickScan 340
- Follett 2 of 5 342
- Appendix A 343
- 334 QuickScan 344
- Standard Cable Pinouts 345
- 336 QuickScan 346
- Appendix B 347
- 338 QuickScan 348
- 340 QuickScan 350
- 342 QuickScan 352
- 344 QuickScan 354
- 346 QuickScan 356
- Default Exceptions 358
- 350 QuickScan 360
- Appendix C 361
- LED and Beeper Indications 362
- NUMBER OF 363
- FLASHES/ 363
- ERROR CORRECTIVE ACTION 363
- 354 QuickScan 364
- Appendix D 365
- Sample bar codes — continued 366
- GS1 DataBar (RSS) 367
- 358 QuickScan 368
- Appendix E 369
- 360 QuickScan 370
- 362 QuickScan 372
- Appendix F 373
- Digital Interface 378
- Digital Interface — cont 379
- IBM31xx 102-key 380
- IBM31xx 102-key — cont 381
- IBM XT — cont 383
- 374 QuickScan 384
- Product Reference Guide 375 385
- 376 QuickScan 386
- ASCII Character Set 387
Manuais e produtos relacionados com Leitores de códigos de barras Datalogic QuickScan QS6500BT
(59 páginas)
(2 páginas)
(50 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.507 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais