Datalogic QS6500BT Especificações descarregar pdf (Página 149)

RSS Limited

Product Reference Guide 139

RSS Limited — continued

RSS Limited Data Group Characters

Once you’ve pre-set your desired Data Group Characters

using the Data Group

Characters

feature found in Chapter 5, Data Editing, you can choose to output

up to two of those pre-sets whenever an RSS Limited bar code is scanned.

To set this feature:

1. Determine which Data Group pre-set(s) to output. You can select up to

two from the following:

Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4

For example, your choice might be Data Group 2 only; Data Groups 1

and 3; Data Groups 3 and 4; or no Data Groups.

2. Scan the START bar code to place the imager in Programming Mode.

3. Scan the SET RSS Limited DATA GROUP CHARACTERS bar code.

4. Turn to

Appendix B, Alpha-Numeric Pad and scan the digits representing

the Data Group designation(s) chosen in the first step above. A digit of

value zero (0) selects “no group.” For example, scanning 3 and 0 would

output only the character(s) set for Data Group 3 whenever an RSS Lim-

ited bar code was scanned. Scanning digits 1 and 2 would output both

Data Groups 2 and 3. To select no Data Groups at all, scan 0, then 0

again.

5. Scan the SET bar code to accept the digits scanned.

6. Scan the END bar code to exit Programming Mode.

1. In that chapter, you can select which character(s) and position(s) to place Data Characters within

scanned data output.

NOTE

The options in this section set Data Group Characters

for the RSS Limited symbology ONLY. If you wish to

enable this feature for additional symbologies, turn to

the options in the section specific to the other symbol-

ogy(s).

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 335 336

Sem comentários

Datalogic QS6500BT Especificações Página 149