Datalogic Magellan 3300HSi Manual de Instruções descarregar pdf (Página 69)

Single Cable RS-232

Product Reference Guide

Single Cable RS-232 Use STX

Enables/disables the ability of the scanner to use STX.

START / END

PROGRAMMING bar codes

Disable STX

Enable STX

DEFAULT

Set Single Cable RS-232 STX Character

This feature selects the STX character.

To specify the STX Character:

1. Scan the START/END bar code.

2. Scan the bar code, SET SINGLE CABLE RS-232 STX CHARACTER below. You’ll need

cover any unused bar codes on this and the facing page to ensure the scanner reads only

the bar code you intend to scan.

3. Scan the appropriate characters/digits from the keypad

in Appendix C, Alpha-Numeric Pad

that represent the decimal designation for the desired character. A table containing the

ASCII Character S

et and their corresponding hex values is available in the inside back

cover of this manual. ASCII parameters must be input by scanning decimal digits for each

character. Pad all numbers with leading zeroes to yield a three-digit entry (001-127).

Thus, to set a single character value of A, bar codes containing the digits ‘0’, ‘6’ and ‘5’

must be scanned. The selectable range for this option is any decimal value from 001 to

127.

4. The scanner will automatically exit Programming M

ode when the appropriate amount of

digits have been scanned.

SET SINGLE CABLE RS-232 STX CHARACTER

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 207 208

Sem comentários

Datalogic Magellan 3300HSi Manual de Instruções Página 69