Datalogic Gryphon BT100 Manual descarregar pdf (Página 7)

Gryphon™ BT Cordless Reading Systems

To disconnect the Host Interface cable, insert a paper clip or other similar object

into the hole corresponding to the Host connector on the body of the cradle. Push

down on the clip while unplugging the cable. Refer to the following figure:

Disconnecting the Cable

CHARGING THE BATTERIES

By placing the reader onto the OM-Gryphon™ BT cradle or C-Gryphon battery

charger it is possible to charge the Gryphon™ BT batteries. Make sure the

charging LED goes on.

The LEDs positioned on the cradle signal the charge status, as described in the

following table:

LED STATUS

Power on /

Data

Yellow On = OM-Gryphon™ BT/C-Gryphon is powered.

Yellow Blinking = OM-Gryphon™ BT receives data and

commands from the Host or the reader.

Yellow Blinking = C-Gryphon receives commands from

the Host.

Charging

Red On = the battery charge is in progress.

Red Blinking = the battery reconditioning is in progress.

Charge

completed

Green On = the battery is completely charged.

Charging +

Charge

completed

Red and Green Blinking together = the reader is not

correctly placed onto the cradle or charger.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Sem comentários

Datalogic Gryphon BT100 Manual Página 7