Datalogic DS8100A-3115 Manual de Instalação descarregar pdf (Página 25)

INTRODUCTION

7. At the last step in the sequence the display prompts to place a barcode label

centered onto the physical X position (X Offset) on the conveyor. Press the ENT

(enter) key to Continue. You have 2 minutes to read the code before the procedure

ends automatically. Be careful that the barcode is not accidentally read in the act of

placing it at the desired X Offset position, and assure that it is read by only one

scanner (see the figure below). After placing the barcode label on the X coordinate,

you may have to pass your hand or other opaque object over it to end this step.

Figure 4 - X Offset Selection

Pressing the ▼ (down arrow) key at any point will terminate the procedure without

saving the Absolute X position alignment.

NOTE

Before resetting the Master scanner, if desired, you can download the Auto

PackTrack Report file from the Master scanner RAM by connecting it to

Genius™ and using the Tools>File transfer… menu. See Help On-Line.

8. Manually reset the Master scanner.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 140 141

Sem comentários

Datalogic DS8100A-3115 Manual de Instalação Página 25