Datalogic DS8100A-3115 Manual de Instalação descarregar pdf (Página 122)

DS8100A REFERENCE MANUAL

108

The ASR procedure is principally used for PackTrack™ configurations, but it restores only a

part of the system parameters: common slave parameters (Code Selection and

Reconstruction) plus each single slave PackTrack™ calibration.

The Master must be prepared at the time of installation in order for this procedure to work

correctly.

10.3.1 ASR Network Configuration

1. On the Master scanner, check the Modify & Backup Lon Slave Scanner

Configuration parameter in Genius™ and configure the Lonworks Slave Scanner

Common Parameters (Code and Reconstruction Parameters).

2. Enable the ASR procedure through the Enable A.S.R. parameter in the Master

configuration.

3. Send the configuration to the Master EEPROM to force the Slave Operating Mode, Code

Reading Symbologies and Reconstruction parameters and store all the Slave

PackTrack™ calibration tables.

Now the Slave scanners are configured through the Master (ASR parameters stored in

the Master) and the ASR procedure is implemented.

4. Save this configuration to file (.ddc).

10.3.2 Scanner Replacement Procedure

NOTE

The ASR procedure requires replacing one scanner at a time.

Slave

1. Power down the entire system.

2. Replace the Slave scanner with a new one (default settings).

3. Power up the system and wait for initialization.

Master

1. Load the saved configuration from file (.ddc) to a new Master scanner.

2. Power down the entire system.

3. Replace the old Master scanner with the new one.

4. Power up the system and wait for initialization.

NOTE

The ASR works only if both the Master and Slave devices have software

6.40 or later.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 140 141

Sem comentários

Datalogic DS8100A-3115 Manual de Instalação Página 122