Datalogic DS4300 Manual de Instalação Página 1

OM4000Installation Manual

OM4000222 INSTALLATIONWhen opening the packaging, verify that the OM4000 oscillating mirror is completewith a set of fixture screws, sealing gasket, a

INSTALLATION322.2 ASSEMBLY TO THE SCANNERFigure 2Figure 3Figure 41) Clean the mirror surface with aclean soft cloth and alcohol beforeassembling it

OM4000422.3 ELECTRICAL CONNECTIONThe OM4000 has a four-wire cable that extends from the compression connector andallows connection to the C-Box of the

INSTALLATION52Scannerwith OM4000C-BoxSystem cablesScannerconnected toC-Boxaccessory cable with9-pin connector wiredto C-Boxaccessory 9-pinconnector so

OM4000622.5 ADJUSTMENTThe OM4000 can be configured to operate in different modes by setting hardwareswitches located inside the oscillating mirror bod

INSTALLATION72MINPOSITIONMAXPOSITIONFREQUENCYERROR LED(red)TRIGGER LED(yellow)TRIGGERED MODEOSCILLATING MODEFigure 10 - Configuration switchesThe rast

OM4000822.5.1 Oscillating ModeIn Oscillating mode, the mirror is in continuous movement between the Min and Maxposition settings. It requires only the

INSTALLATION92NOTEThe Min Position value must be less than the Max Position (2 switchpositions). The aperture limits in the following table also apply

OM40001022.5.2 Triggered ModeWith this operating mode the oscillating mirror movement is stopped after the readingphase OFF signal (EXT TRIG becomes i

INSTALLATION112NOTEThe Min Position value must be less than the Max Position (2 switchpositions). The aperture limits in the following also apply.Hz M

OM4000Installation Manual

OM40001222.5.3 Fixed ModeFixed mode allows you to position the laser beam at any angle between +20° and-20° with respect to the mounting position of t

MAINTENANCE AND TROUBLESHOOTING1333 MAINTENANCE AND TROUBLESHOOTINGOM4000 has no user replaceable components and, apart from periodically cleaningthe

OM400044 TECHNICAL FEATURESELECTRICAL CHARACTERISTICSOperating voltageInput current maxPower consumption maxRaster widthOscillation frequency10 to 30

READING DIAGRAMAA READING DIAGRAMSA.1 EXAMPLE READING DIAGRAMThe following reading diagram is given as an example of performance that can beobtained i

OM4000INSTALLATION MANUAL

DATALOGIC S.p.A.Via Candini 240012 – Lippo di Calderara di RenoBologna - ItalyOM4000Ed.: 03/2002ALL RIGHTS RESERVEDDatalogic reserves the right to mak

iiiCONTENTSGENERAL VIEW ...ivSAFETY PRECAUTIONS...

ivGENERAL VIEWOM4000Figure A1 2Warning LabelLaser Beam Output Window21

vSAFETY PRECAUTIONSWARNINGOnce the scanner-oscillating mirror reading system is assembled,the laser beam is emitted from the output window of the OM40

vi

INTRODUCTION111 INTRODUCTIONThe OM4000 oscillating mirror is an accessory for the 4000 series laser scanners:DS41, DS4300, DS4600. It is designed to g