Datalogic Dragon D131 Especificações Página 20
- Página / 210
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
DRAGON™ DX31/MX31
10
2.8.3 Network Termination
The first and last cradles of the chain (the two ends of the bus) must be properly
terminated. The cradle has an internal terminator that can be selected via jumper.
For this selection you must open the device.
No Termination Static Dynamic
Terminator for Multidrop Network
Static termination works for all network configurations. However, the network is
always under load even when no data transmission takes place.
Dynamic termination can be used for baud rates at or above 38400 and provides less
load on the network when idle.
- Dragon™ D131/M131 1
- Reference Manual 1
- CONTENTS 3
- GENERAL VIEW 9
- 1 INTRODUCTION 11
- 2 INSTALLATION 12
- INSTALLATION 13
- CAUTION 13
- 2.3 RS232 CONNECTION 15
- 2.4 USB 15
- 2.5 IBM USB POS 16
- 2.6 WEDGE CONNECTION 17
- 2.7 PEN EMULATION CONNECTION 17
- 2.8 NETWORK CONNECTIONS 18
- 2.8.2 Network Cabling 19
- 2.8.3 Network Termination 20
- 2.9.1 Battery Charging 21
- 2.10.1 Desktop mounting 23
- Portable Desktop Use 24
- Fixed Desktop Use 24
- 2.10.2 Wall Mounting 26
- Inclined Base Wall-mounting 27
- LAYOUTS 28
- 3.1.4 C-BOX Layout 30
- 3.2.1 Host Master Layout 31
- 3.2.2 OM-3000 Master Layout 32
- /*32: FAIL*/ 33
- 4 CONFIGURATION 34
- 4.2 SETUP PROCEDURES 35
- Ì$+$*oÎ 36
- ÌIB'Î 37
- ÌRA0RFHÎ 38
- Ì$+RN0$-IÎ 38
- Ì$+RX0$-qÎ 39
- Ì$+RN1$-NÎ 39
- END of procedure 40
- Ì$+RF4Î 43
- Ì$+RZ2$-ÇÎ 44
- Ì$+RZ1$-~Î 44
- Ì$+CP0$-$Î 45
- Ì$+CM2EC0$->Î 45
- Ì$+CM1$-ÈÎ 45
- Ì$+CM0$-ÃÎ 45
- Ì$+CP6$-BÎ 45
- Ì$+CP512$-uÎ 48
- Ì$+CP513$- 48
- First Start-Up 49
- CONFIGURATION 51
- RS232 PARAMETERS 52
- BAUD RATE 53
- DATA BITS 54
- STOP BITS 54
- HANDSHAKING 54
- ACK/NACK PROTOCOL 55
- INTER-CHARACTER DELAY 55
- RX TIMEOUT 56
- SERIAL TRIGGER LOCK 56
- USB PARAMETERS 57
- USB-COM 58
- USB-KBD 60
- KEYBOARD NATIONALITY 60
- INTER-CODE DELAY 62
- USB KEYBOARD SPEED 62
- WEDGE PARAMETERS 63
- CAPS LOCK 65
- NUM LOCK 66
- KEYBOARD SETTING 67
- CONTROL CHARACTER EMULATION 69
- PEN EMULATION 70
- OPERATING MODE 71
- MINIMUM OUTPUT PULSE 72
- OVERFLOW 73
- OUTPUT LEVEL 74
- IDLE LEVEL 74
- INTER-BLOCK DELAY 74
- NETWORK PARAMETERS 75
- RS485 NETWORK 76
- NETWORK BAUD RATE 76
- SLAVE ADDRESS RANGE 77
- NETWORK WARNING MESSAGE 77
- RECEPTION WARNING MESSAGE 77
- MASTER CRADLE HEADER 78
- MASTER CRADLE TERMINATOR 79
- DATA FORMAT 80
- CODE IDENTIFIER 82
- CUSTOM CODE IDENTIFIER 82
- TERMINATOR 84
- SPECIAL KEYS 85
- FIELD ADJUSTMENT 86
- FIELD ADJUSTMENT CHARACTER 87
- CODE LENGTH TX 87
- CHARACTER REPLACEMENT 88
- POWER SAVE 92
- SLEEP STATE 93
- ENTER SLEEP TIMEOUT 93
- READING PARAMETERS 94
- TRIGGER TYPE 95
- TRIGGER SIGNAL 95
- TRIGGER CLICK 95
- TRIGGER-OFF TIMEOUT 96
- FLASH MODE 96
- READS PER CYCLE 96
- SAFETY TIME 97
- BEEPER INTENSITY 97
- BEEPER TONE 98
- BEEPER TYPE 98
- BEEPER LENGTH 98
- GOOD READ SPOT DURATION 99
- AIMING SYSTEM 99
- CRADLE BEEPER INTENSITY 99
- DECODING PARAMETERS 100
- INK SPREAD 101
- OVERFLOW CONTROL 101
- INTERDIGIT CONTROL 101
- DECODING SAFETY 102
- PUZZLE SOLVER™ 102
- CODE SELECTION 103
- Ì#+AUTOWÎ 104
- EAN/UPC FAMILY 106
- 2/5 FAMILY 112
- CODE 39 FAMILY 113
- CODE 128 FAMILY 114
- CODE 93 115
- CODABAR FAMILY 115
- CODE 11 118
- CODE 16K 119
- CODE 49 119
- RSS CODES 120
- ADVANCED FORMATTING 121
- CONCATENATION 122
- RADIO PARAMETERS 140
- RADIO PROTOCOL TIMEOUT 141
- POWER-OFF TIMEOUT 141
- TRANSMISSION MODE 142
- SINGLE STORE 143
- BATCH MODE 144
- FIND ME 144
- DISPLAY PARAMETERS 145
- DATE AND TIME 146
- CONTRAST 146
- FONT SIZE 146
- BACKLIGHT 146
- DISPLAY-OFF TIMEOUT 147
- DISPLAY MODE 147
- 5 REFERENCES 149
- 5.1.2 ACK/NACK Protocol 150
- 5.1.3 FIFO 151
- 5.1.4 RX Timeout 152
- 5.2 PEN PARAMETERS 152
- 5.2.1 Minimum Output Pulse 152
- 5.2.3 Overflow 153
- 5.2.5 Inter-Block Delay 154
- 5.3 NETWORK PARAMETERS 154
- 5.4 DATA FORMAT 155
- Enter Configuration 157
- DRAGON™ D131/M131 160
- ÌFQ9C2>Î 162
- 5.4.3 Address Stamping 164
- 5.4.4 Address Delimiter 164
- 5.4.5 Time Stamping Format 165
- 5.5 POWER SAVE 165
- 5.5.1 Sleep State 165
- 5.6.5 Safety Time 167
- 5.7 DECODING PARAMETERS 167
- 5.7.1 Ink-Spread 167
- 5.7.2 Overflow Control 167
- 5.7.3 Interdigit Control 168
- 5.8 ADVANCED FORMATTING 168
- 5.8.1 Match Conditions 168
- 5.9.2 Power-Off Timeout 169
- 5.9.3 Transmission Mode 169
- 5.9.5 Single Store 170
- 5.9.6 Batch Mode 171
- 5.10.1 Display Mode 172
- Ì$+$0ÂÎ 174
- Ì$+$1$Î 174
- Ì#+CODEÂÎ 174
- Ì$+ZZ0$-*Î 175
- Ì$+ZZ2$-4Î 176
- Ì$+ZZ3$-9Î 177
- Ì$+RN2$-SÎ 179
- 6 MESSAGE FORMATTING 180
- 6.1.1 Cursor Control 181
- 6.1.2 Font Selection 182
- 6.1.3 Clearing Display 182
- 6.1.5 Setting RTC 183
- 7 TECHNICAL FEATURES 185
- 7.2 DRAGON™ M131 186
- 7.3 OM-30X0 / C-3000 187
- 7.5 STATUS INDICATORS 188
- 7.6 READING DIAGRAMS 191
- AC410132BH0 192
- SERIAL CONFIGURATION STRINGS 193
- (not for USB-KBD-ALT-MODE) 195
- (IBM AT compatible only) 195
- (only for D131 series) 200
- B CODE IDENTIFIER TABLE 206
- C HEX AND NUMERIC TABLE 209
Manuais e produtos relacionados com Leitores de códigos de barras Datalogic Dragon D131
(2 páginas)
(38 páginas)
(15 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.033 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais