Datalogic M-Series Especificações descarregar pdf (Página 170)

DRAGON™

158

5.11.2 Copy DRAGON



 M-Series

Procedure:



Using the slave reader and its OM-DRAGON™ cradle, follow the initialization

procedure in chapter 4 of this manual or from the Quick Reference Manual.



With the master DRAGON M (correctly configured reader), read the Copy

Configuration barcode below. Then place it onto an OM-DRAGON™ cradle

within 10 seconds. The reader will beep indicating the configuration has been

copied.

The configuration will be simultaneously sent over the RS232 interface of the

OM-DRAGON™. If this causes undesired effects disconnect the RS232 cable

between the PC and OM-DRAGON™ during this process.

Copy Configuration

i;;k

$+ZZ0$-



With the slave DRAGON M, read the Get Configuration barcode below. Then

place it onto the same OM-DRAGON™ cradle used in the step above. The

slave reader's address will not be changed.

Get Configuration

i;;k

$+ZZ2$-

The configuration will be copied from the master to the slave DRAGON M. The

slave DRAGON M signals the end of the procedure with a series of beeps. It is

now ready to be used with its own OM-DRAGON™ cradle.



Repeat the procedure above to configure other slave readers. The

OM-DRAGON™ can continue to configure slave readers until it receives

another command or data.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 202 203

Sem comentários

Datalogic M-Series Especificações Página 170