Datalogic Compact 2D Reader Matrix-2000 Manual de Instruções descarregar pdf (Página 40)

MATRIX-2000™ REFERENCE MANUAL

NOTE

To avoid electromagnetic interference when the reader is connected to a

CBX connection box, verify the jumper positions in the CBX as indicated in

its Installation Manual.

4.1 POWER SUPPLY

Power can be supplied to the reader through the CBX100/500 spring clamp terminal pins as

shown in Figure 41:

V+

Earth

Ground

Power Supply

VGND

Figure 41 - Power Supply Connections

The power must be between 10 and 30 Vdc only.

It is recommended to connect the device CHASSIS to earth ground (Earth) by setting the

appropriate jumper in the CBX connection box. See the CBX Installation Manual for details.

4.2 MAIN SERIAL INTERFACE

The signals relative to the following serial interface types are available on the CBX spring

clamp terminal blocks.

The main serial interface type and its parameters (baud rate, data bits, etc.) can be

defined by the user via VisiSet™ software. The RS485 half duplex is automatically set

whenever MUX32 communication protocol is enabled. For more details refer to the

"Communication" folder in the VisiSet™ Help On Line.

Details regarding the connections and use of the interfaces are given in the next paragraphs.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 107 108

Sem comentários

Datalogic Compact 2D Reader Matrix-2000 Manual de Instruções Página 40