Datalogic CBX500 Manual de Instalação descarregar pdf (Página 17)

INSTALLATION

2.1.1 Frame Width

The frame Width has to be calculated according to the distances shown in the following

figure:

STS Main Plate Dimensions

STS400-xx7 and -xx8 = 1065 mm

(41.9 in)

STS400-xx5 and -xx6 = 785 mm

(30.9 in)

STS Main Plate

Conveyor Width

Max Side Room

Safe Safe

Max Side Room

The Safe clearance between the frame and the conveyor sides has to be chosen according

to the Maximum Side Room available. It is suggested to always keep at least of 200 mm of

Safe clearance.

The length of the frame profiles W can be calculated in 2 ways, according to whether the

STS400™ main plate is wider than the conveyor Conveyor Width or not:

If Conveyor Width > STS Main Plate then:

W = Conveyor Width + (2 * Safe Margin)

If Conveyor Width  STS Main Plate then:

W = STS Main Plate + (2 * Safe Margin)

Note: The STS400-xx7 models require a 70 or 55 mm shift to center the FOV over the

conveyor and therefore must be accounted for in the frame width calculation.

2.1.2 Frame Length

It is suggested to keep at least 500 mm of Safe clearance for the frame Length (L). This

allows good frame stability and freedom for moving both the reading phase sensor(s) and the

STS400™, forward or backward:

Reading Phase

Sensors

Note: There is not a specific calculation for (L).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 64 65

Sem comentários

Datalogic CBX500 Manual de Instalação Página 17