Datalogic Jet Manual do Utilizador descarregar pdf (Página 74)

1 MEMOR™ X3

4. Carefully press and briefly hold stylus on the center of the target. Repeat as the

target moves around the screen. Press the Esc key to cancel the stylus

calibration:

5. Press the Enter key or tap the screen to accept the new calibration settings.

Press the Esc key to keep the old settings.

New calibration settings are persistently saved in the Registry.

Startup Stylus Calibration

When starting the terminal, a stylus calibration screen comes up if valid calibration

settings are not available. This happens in the following circumstances:

1. At the first startup of the terminal.

2. After restoring registry default settings using the applet Registry Admin and

performing a warm boot.

3. After a Clean Boot.

4. After a Firmware Update (see section 4.8.3)

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 153 154

Sem comentários

Datalogic Jet Manual do Utilizador Página 74